Synthesis of Molecular Imprinting Polymers Separating Toluic Acid Isomers (II)

Polymers that can separate toluic acid isomers were synthesized by molecular imprinting technique. Molecular imprinting polymers (MIPs) for each isomer of toluic acids (TA) were synthesized using styrene and 4-vinylpyridine (4-Vpy). The adsorption characteristics of TA isomers, salicylic acid (SA), and benzoic acid (BA) on each MIP were investigated. The materials used for polymerization of TA isomers MIPs were adsorbed relatively well. This verifies that the MIPs which can adsorb template selectively were synthesized. In addition, the quantities of adsorbed TA isomers on the TA isomers MIPs and on the control polymer polymerized without template were compared and discussed. The variation of adsorption ability for MIPs with repeated use was investigated, showing excellent reproducibility.     

Characteristics of roadside air pollution in Korean metropolitan city (Daegu) over last 5 to 6 years: temporal variations, standard exceedances, and dependence on meteorological conditions

The present study performed a roadside data analysis to provide baseline data for exploring associations between environmental exposure to four gaseous pollutants and health effects on residents living near roadways. The yearly roadside concentrations of CO and SO₂ showed a well-defined decreasing trend, whereas those of NO₂ and O₃ exhibited the reverse trend. In most cases, the diurnal trends of the roadside concentrations were well-defined for all seasons, plus the daytime concentrations were higher than the nighttime concentrations. In contrast to the other target pollutants, the daytime O₃ concentrations observed at the roadside sites were lower than those observed at the residential site, likely due to high-levels of fresh NO from traffic emissions that rapidly react with O₃, thereby reducing the O₃ roadside level. The Sunday roadside concentrations of CO, NO₂, and SO₂ were similar to or somewhat lower than the weekday concentrations. Conversely, for O_3, the Sunday roadside concentrations were similar to or somewhat higher than the weekday concentrations. The higher O₃ concentrations on Sunday may be due to the reduced titration from a decrease in NO_x emissions under VOC-limited conditions (low VOC/NO_x conditions). The monthly averages of O₃ concentrations exhibited the reverse seasonal variation to the other target compounds, with peak O₃ concentrations between April and June, and the second peak between August and October. It is also suggested that for O₃, the 8-h standard is more stringent than the 1-h standard, while for NO₂ and SO₂, the 1-h standard is more stringent than the 24-h standard. The multiple regression equations obtained from the relationship between the concentrations and five meteorological parameters indicated that the number and type of meteorological variables in the equations varied according to the pollutant, monitoring station, or season.     

Iron and organo-bentonite for the reduction and sorption of trichloroethylene

Hybrid barriers using dechlorination and immobilization were studied to remove trichloroethylene (TCE) in this study. Hybrid barriers of iron filings and organo (hexadecyltrimethylammonium, HDTMA)-bentonite were simulated in columns to assess the performance of the hybrid barriers. TCE reduction rate for the mixture of zero valent iron (ZVI) and HDTMA-bentonite was approximately seven times higher than that for ZVI, suggesting the reduction of TCE was accelerated when HDTMA-bentonite was mixed with ZVI. For the column of two separate layers of iron and HDTMA-bentonite, TCE reduction rate was nearly similar to that for ZVI alone, but the partition coefficient (Kd) was 4.5 times higher than that for ZVI only. TCE was immobilized in the first layer with HDTMA-bentonite due to sorption, and then dechlorinated in the second layer with iron filings due to reduction. The HDTMA-bentonite and minimally-desorbed HDTMA from the organo-bentonite are believed to contribute the increase in TCE concentration on iron surface so that more TCE could be available for reduction. Therefore, the incorporation of HDTMA-bentonite into ZVI not only can effectively retard the transport of chlorinated organic contaminants from landfill leachate or oil shock in subsurface environment, also can expedite the reduction rate of TCE.     

Calculation of environmental concentration and comparison of output for existing chemicals using regional multimedia modeling

The environmental fate of 40 existing chemicals is discussed using the EUSES multimedia distribution and risk assessment model with site-specific parameter setting in an urban area of Japan including a highly industrial region. There has been a strong need to assess the environmental fate of a huge number of existing chemicals. Data on the emission amounts of chemicals are essential for such prediction, and PRTR surveys may yield this data. The study delivered the following results: (1) Volatile compounds with large amounts of emission showed higher predicted concentrations in air, and the concentrations of several compounds agreed well with averaged monitoring data within an order of magnitude. (2) A close relationship was found between the concentration of water and that of sediment, suggesting that the fate of chemicals in sediment essentially depended on the water environment. (3) A group of volatile solvents had high mass distribution ratio to air. Some compounds having high solubility in water were also included in that group due to the high ratio of air emission. Highly hydrophobic compounds with logK(OW) larger than 6.0 showed a high distribution ratio to soil and sediment. (4) Volatile compounds were mostly taken through air. The exposure through fish is a dominant pathway for highly hydrophobic compounds. (5) Exposure ratio could be gathered from physicochemical properties. The exposure from fish intake was roughly estimated by logK(OW), whereas exposure from air and water intake was difficult to estimate simply by vapor pressure and solubility in water, respectively.     

The effect of emergent macrophytes on the dynamics of sulfur species and trace metals in wetland sediments

This study focuses on the effect of plants on the biogeochemistry of sulfur species and the mobility of heavy metals in wetland sediments. Results showed that, in the presence of plants, sediments had elevated sulfate concentrations in the rhizosphere during the growing season, ranging from 0.2 to 6.20 mmol L(-1), whereas only a small difference in the sulfate profiles between vegetated and non-vegetated sediments was observed during senescence. Based on the sulfate concentration increase, the oxygen release rate from the roots to achieve the corresponding oxidation of sulfide was estimated as 0.85 g m(-2) day(-1). Evapotranspiration-induced advection is a major contributor to the transport of sulfate from the water column into the sediments, and also allows dissolved trace metals (i.e. Cd, Pb, and Zn) to be transported into the sediments and react with the acid volatile sulfide pool, resulting in the immobilization of trace metals in these sediments.     

Comparison of particle light scattering and fine particulate matter mass in central California

Particle light scattering (Bsp) from nephelometers and fine particulate matter (PM2.5) mass determined by filter samplers are compared for summer and winter at 35 locations in and around California's San Joaquin Valley from December 2, 1999 to February 3, 2001. The relationship is described using particle mass scattering efficiency (sigmasp) derived from linear regression of Bsp on PM2.5 that can be applied to estimated PM2.5 from nephelometer data within the 24-hr filter sampling periods and between the every-6th-day sampling frequency. An average of sigmaSp = 4.9 m2/g was found for all of the sites and seasons; however, sigmasp averaged by site type and season provided better PM2.5 estimates. On average, the sigmasp was lower in summer than winter, consistent with lower relative humidities, lower fractions of hygroscopic ammonium nitrate, and higher contributions from fugitive dust. Winter average sigmasp were similar at non-source-dominated sites, ranging from 4.8 m2/g to 5.9 m2/g. The sigmasp was 2.3 m2/g at the roadside, 3.7 m2/g at a dairy farm, and 4.1 m2/g in the Kern County oilfields. Comparison of Bsp from nephelometers with and without a PM2.5 inlet at the Fresno Supersite showed that coarse particles contributed minor amounts to light scattering. This was confirmed by poorer correlations between Bsp and coarse particulate matter measured during a fall sampling period.     

雨雪冰冻灾害后粤北森林各林型凋落物动态

为了考察中国亚热带不同森林类型对雨雪冰冻灾害的响应模式,以粤北天井山3种代表性的林型—针叶林、阔叶林和混交林为对象,于不同森林类型中比较受损森林与未受损森林在凋落物年产量、成分及月际动态方面的差异,从而在凋落物水平上反映不同森林类型在雨雪冰冻灾害后的早期恢复力。研究结果表明,灾后针叶林、阔叶林和混交林的年凋落量分别为0.52、3.21、1.37 t.hm-2,比未受损的同种森林类型年凋落量显著减少,减少程度分别为87.89%、53.46%、76.78%。由此可以看出阔叶林的植被恢复情况最好,说明在凋落物水平上,其灾后恢复的早期阶段恢复力最强。在凋落物成分方面,灾后各森林类型叶凋落物所占比例显著增加,枝凋落物所占比例则显著减少。受损针叶林和阔叶林的凋落物月动态与未受损森林基本一致,但其波动幅度较小;在混交林中,受损和未受损森林其凋落量的季节动态模式则表现出不一致性且为不规则型。根据研究结果,建议在亚热带地区优先考虑种植阔叶林以促进受损森林在类似雨雪冰冻灾害的极端天气后的恢复。     

Intentionally building relationships between participatory online groups and formal organisations for effective emergency response

Advances in information and communication technologies enable the public to contribute to emergency response. For instance, reporting systems set up during recent disasters allowed affected people to submit testimonies about conditions on the ground. In addition, the public has analysed data and helped to mobilise and deliver relief resources. To plan intentionally for an integrative emergency response system in the networked age, this research explores two subject areas: (i) the organisational and technical determinants of relationships forged between formal organisations and participatory online groups established by the public; and (ii) the consequences of the outcomes generated by these relationships. Four in‐depth case studies were selected for the analysis, which revealed that resource dependence, shared understanding, and the use of certain types of information technology influence the formation of such relationships. Furthermore, healthy collaborative relationships increase the chances of desirable results, including inter‐organisational alignment and minimal long‐term harm owing to a disaster.     

Absorption characteristics of potassium carbonate-based solutions with rate promoters and corrosion inhibitors

In this research, absorbents for CO₂ capture were prepared by blending 30 wt% potassium carbonate, 3 wt% of a rate promoter, and 1 wt% of a corrosion inhibitor. Pipecolic acid, sarcosine, and diethanolamine were chosen as rate promoter candidates. Based on a rate promoter screening test for CO₂ loading capacity and absorption rate, pipecolic acid and sarcosine were selected to be used as rate promoters. 1,2,3-benzotriazole and ammonium thiocyanate were chosen as corrosion inhibitors, and they were mixed with a 30 wt% potassium carbonate-based absorbent mixture containing one of the rate promoters. The absorption rates for four absorbent solutions (30 wt% potassium carbonate?+?3 wt% pipecolic acid?+?1 wt% 1,2,3-benzotriazole, 30 wt% potassium carbonate?+?3 wt% pipecolic acid?+?1 wt% ammonium thiocyanate, 30 wt% potassium carbonate?+?3 wt% sarcosine?+?1 wt% 1,2,3-benzotriazole, and 30 wt% potassium carbonate?+?3 wt% sarcosine?+?1 wt% ammonium thiocyanate) were measured, tabulated, and graphically displayed. These types of absorbents can be used for capturing CO₂ under high temperature and pressure conditions, such as those found in coal-fired power plants.